Yagi Antenna Design and Analysis - TANN THONA

Department of Telecommunication and Electronic Engineering

Hot

Post Top Ad

Thursday, July 26, 2018

Yagi Antenna Design and Analysis

Yagi Antenna Design and Analysis

I. Objective

In this experiment describe about of RF Environment Analysis course since 17 November 2017. For that time, we have studied about how to analyze the FM radio frequency around Phnom Penh by using the Yagi antenna which design for receive FM signal and also using Spectrum Analyzer to connect with our Yagi antenna to process in this experiment.

II. Theory

To design Yagi antenna, we need to select one of FM frequencies from 88MHz to 108MHz to calculate the wavelength. Which the wavelength is known that (𝞴) and its formula:
𝛌=𝒄/𝒇 ;
Where c is the light length is 3x108 measure by m.s
And
  • Dipole ANT = 0.473 x λ
  • Reflector = 0.495 x λ
  • Director = 0.440 x λ
  • Space of each element = 0.125 x λ
Figure 1: Yagi antenna.

III. Equipment

To process the experiment for this lab we need equipment such as:
  • Compass: using for location of FM radio station.
  • Yagi Antenna (Frequency 105MHz): use it to analyze signal from FM radio station.
  • Spectrum Analyzer (RIGOL, DSA705, S/No: DSA8B182500542): use it to analyze FM signal from FM radio through the antenna.
Figure 2: Spectrum Analyzer (RIGOL DSA705).

IV. Methodology

Firstly, we need to design the Yagi antenna for receive FM signal. After that, we have connected the designed antenna to Spectrum Analyzer to process our experiment.
During the experiment, we need to use reference frequencies of FM radio station to analyze on Spectrum Analyzer, next we rotated the antenna to find strength signal of Gain and find its direction by compass.
Finally, if the antenna can find the strength signal direction, then we have noted these information as the result and do it with the different reference frequencies of FM radio around Phnom Penh.

V. Result and Discussion

After we finished those experiment we have got some information about it and collected it in the table below.

Table 1: Experiment result from Spectrum Analyzer.

According to the table above, for 2nd column is the reference frequencies of FM radio in Cambodia, 3rd column is the measurement frequencies, and 4th column is the gain value of measurement in Spectrum Analyzer with 3 elements Yagi antenna receiver, and the 6th column is the direction of radio station which we got higher signal. By the 4th column of Gian there are 7 results from experiment, those values mean that if the gain value is bigger, so the strength signal that we got is higher. The gain value is smaller, the strength signal will be lower.

VI. Conclusion

After we have an experiment, we can conclude that the direction of high signal by rotation is also the direction of its FM radio station.
If the Gain value is bigger than other value, so the signal of it is also stronger than other in this above graph and it also high signal if radio station nearby our experiment.





Royal University of Phnom Penh
Faculty of Engineering
Dep. Telecommunication and Electronic Engineering

Group Member:
1. Ly Seyha
2. Tann Thona
3. Nop Da
4. Sim Pichdany
Instructor: Dr. Bae Dae Hwan
Experiment Date: 17 November 2017




Photos

Date: 10, 17, 24 November and 1, 8 December 2017
Location: Royal University of Phnom Penh, Cambodia
Take Photos by Tann Thona












Photos Design Yagi 10 Element Antenna

Date: 29 March 2018 and 24 April 2018
Location: Royal University of Phnom Penh, Cambodia
Take Photos by Tann Thona and Pov Vannak


 









1 comment:

Post Top Ad